BNTRN - WELD-ON 1707 FOR ABS PLASTIC
- MSDS: BNTRN
- Manufacturer: INDUSTRIAL POLYCHEMICAL SERVICE
- Product Name: WELD-ON 1707 FOR ABS PLASTIC
- National Stock Number: 8040-01-235-2642
Product Identification
Product ID:WELD-ON 1707 FOR ABS PLASTIC
MSDS Date:01/01/1987
FSC:8040
NIIN:01-235-2642
MSDS Number: BNTRN
Responsible Party
GARDENA, CA 90248
US
Emergency Phone: 213-321-6515
Cage: 17510
Contractor
Telephone: 310-898-3300
Cage: 17510
Ingredients
ACRYLONITRILE BUTADIENE STYRENE RESIN (ABS)
CAS: 9003-56-9
Fraction By Weight: 15-25%
METHYL ETHYL KETONE (MEK)
CAS: 78-93-3
RTECS: EL6475000
Fraction By Weight: 75-85%
OSHA PEL 200 PPM
ACGIH TLV: 200 PPM
EPA Report Quantity: 5000 LBS
DOT Report Quantity: 5000 LBS
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Effects of Overexposure:SEVERE OVEREXPOSURE MAY RESULT IN NAUSEA,
DIZZINESS, HEADACHE. CAN CAUSE NARCOSIS, IRRITATION OF EYES AND
NASAL PASSAGES. MAY IRRITATE SKIN. NORMAL DEFATTING EFFECT OF
SOLVENTS ON TISSUE.
First Aid
First Aid:INHAL: IF OVERCOME BY VAPORS: REMOVE TO FRESH AIR, IF
BREATHING STOPPED-GIVE ARTIFICIAL RESPIRATION (PREFER MOUTH TO
MOUTH). IF BREATHING DIFFICULT-GIVE OXYGEN. CALL DR. EYE: FLUSH
W/PLENTY OF WATER F OR 15 MINS. CALL DR. SKIN: REMOVE CONTAMINATED
CLOTHING/SHOES. WASH WITH WATER FOR 15 MINS-CALL DR. INGEST: GIVE 1
OR 2 GLASSES OF WATER OR MILK AND INDUCE VOMITING. CALL DR
IMMEDIATELY.
Fire Fighting
Flash Point Method:TCC
Flash Point:21.0F,-6.1C
Lower Limits:1.8
Upper Limits:10.0
Extinguishing Media:DRY CHEMICAL, CARBON DIOXIDE, FOAM - ANSUL "PURPLE
K" - NATIONAL AER-O-FOAM, WATER FOG.
Fire Fighting Procedures:EVAC AREA/STAY UPWIND. CLSE/CONFND QTRS REQ
SCBA; POSITIVE PRESS HOSE/AIRLINE MASKS. USE WTR SPRAY: COOL
CNTNRS/FLUSH SPILLS FROM SOURCE OF IGNIT/DISPERSE VAPOR
Unusual Fire/Explosion Hazard:FIRE HAZARD BECAUSE OF LOW FLASH POINT
AND HIGH VOLATILITY. VAPORS ARE HEAVIER THAN AIR AND MAY TRAVEL TO
SOURCE OF IGNITION.
Accidental Release
Spill Release Procedures:ELIM ALL IGNIT SOURCES. AVOID BREATH OF
VAPORS. KEEP LIQ OUT OF EYES. FLUSH W/LG VOL OF WTR. CONTAIN LIQ
W/SAND OR EARTH. ABSORB W/SAND OR NONFLAMMABLE ABSORB MATL &
TRANFER INTO STEEL DRUMS FOR RECOV ERY OR DISPOSAL. PREVENT LIQ
FROM ENTERING DRAINS.
Handling
Handling and Storage Precautions:STORE IN SHADE BETWN 40F & 110F. KEEP
FROM: HEAT/SPARKS/OPEN FLAME & OTHER SOURCES OF IGNITION. AVOID
PROLONGED BREATHING OF VAPOR. USE W/ADEQ VENT.
Other Precautions:FOLLOW ALL PRECAUTIONARY INFORMATION GIVEN ON THE
CONTAINER LABEL, PRODUCT BULLETIN & OUT CEMENTING LITERATURE. ALL
HANDLING EQUIPMENT SHOULD BE ELECTRICALLY GROUNDED.
Exposure Controls
Respiratory Protection:NONE REQUIRED WITH ADEQUATE VENTILATION. USE
NIOSH APPROVED RESPIRATOR FOR ORGANIC VAPORS FOR CONFINED AREAS,
E.G., MINE SAFETY APPLIANCE CAT. #459433.
Ventilation:PROVIDE ADEQUATE VENTILATION. VAPOR CONCENTRATION MUST BE
KEPT WELL BELOW TLV.
Protective Gloves:RUBBER OR PVA
Eye Protection:CHEMICAL GOGGLES
Other Protective Equipment:IMPERVIOUS APRON (IF NEEDED)
Supplemental Safety and Health
Chemical Properties
Boiling Pt:B.P. Text:175.2
Vapor Pres:71.2 @ 23C
Vapor Density:2.5
Spec Gravity:0.870 + 0.006
Evaporation Rate & Reference:(BUAC = 1) APPROX 5.7
Solubility in Water:27.1 (SOLVENT)
Appearance and Odor:MILKY, TRANSLUCENT, MEDIUM SYRUPY LIQUID. KETONE
ODOR.
Percent Volatiles by Volume:85-90
Stability
Stability Indicator/Materials to Avoid:YES
CAUSTICS, AMMONIA, INORGANIC ACIDS, CHLORINATED COMPOUNDS, STRONG
OXIDIZERS AND ISOCYNATES.
Stability Condition to Avoid:KEEP FROM: HEAT/SPARKS/OPEN FLAME/OTHER
SOURCE OF IGNITION. THIS LIQ IS VERY STABLE AT NORMAL AMBIENT
TEMPERATURES.
Hazardous Decomposition Products:DENSE SMOKE CONTAINING CARBON
MONOXIDE, CARBON DIOXIDE AND HYDROGEN CYANIDE.
Conditions to Avoid Polymerization:KEEP AWAY FORM HEAT, SPARKS, OPEN
FLAME AND OTHER SOURCES OF IGNITION.
Disposal
Waste Disposal Methods:FOLLOW LOCAL, STATE AND FEDERAL REGULATIONS.
CONSULT DISPOSAL EXPERT. CAN BE DISPOSED OF BY INCINERATION.
EXCESSIVE QUANTITIES SHOULD NOT BE PERMITTED TO ENTER DRAINS.
HAZARDOUS WASTE CODE: U159
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.